A true high-build restoration membrane: fully adhered, seamless, formed-in-place, and chemically cured. Not a paint-like coating, thin-mil surface treatment, or seam-dependent overlay.
PolyArmor Hybrid is installed as a single monolithic application, engineered to a demanding set of performance minimums rather than a generic coating spec.
50 to 100 percent with internal fiber or scrim reinforcement
Adhesion
Full bond to approved prepared substrates, minimum 50 psi
Waterproofing Integrity
No field seams, laps, or mechanically fastened membrane sheets in the roof field
Durability
Tough, weather-resistant elastomeric film, minimum 85 Shore A durometer
Reinforcement
Internal fiber or scrim required
Not a Coating. A Restoration Membrane.
Systems relying primarily on multiple thin coats to achieve film build, or functioning as surface coatings rather than fully adhered monolithic membranes, are not equivalent to PolyArmor Hybrid. Specifically excluded as substitutions:
Acrylic roof coatings
Silicone roof coatings
Asphaltic reflective coatings
Aluminum coatings
Low-build coating systems
Multi-coat base and finish systems
Mechanically attached membrane overlays
Loose-laid or seam-dependent assemblies
Why PolyArmor Hybrid Is Different
PolyArmor is a liquid-applied, chemically cured roof restoration system that forms a seamless, monolithic membrane directly over the existing roof surface.
Fully Bonded
Full adhesion resists lateral water migration beneath the membrane instead of relying on mechanical attachment.
Seamless Application
Eliminates field seams in the completed membrane, applied in a single monolithic pass at 80 mils nominal.
Chemically Cured
High-solids, chemically cured formulation, not air-dried, built for tough long-term exposure.
Conforms Around Penetrations
Fully encapsulates seams, curbs, drains, and penetrations for continuous watertight coverage.
Restoration Instead of Replacement
Restores more, tears off less, reducing landfill waste and disruption to building operations.
Installed With Quality Control Built In
Preparation
Roof inspection, adhesion testing, surface cleaning, and repairs to seams, drains, curbs, and penetrations before any membrane goes down.
Application
Controlled grid layout, measured coverage rates, notched squeegee application, and cross-rolling to achieve proper film thickness.
Verification
Wet-film thickness verification, batch and installation documentation, and post-installation inspection on every project.
Where PolyArmor Hybrid Fits
Modified Bitumen
Smooth and granulated asphaltic roofing
Metal roofing
Approved aged single-ply roofing
Other substrates accepted in writing by the manufacturer
Commercial Roofs Usually Fail in Predictable Places
Most flat roof failures begin at the weak points:
Seams
Laps
Fasteners
Penetrations
Flashings
Termination Points
Areas where water can migrate beneath the membrane
Why Building Owners Choose PolyArmor
Avoid unnecessary tear-off when restoration is viable
Improve waterproofing performance
Reduce landfill waste
Help localize future leak issues
Minimize disruption to building operations
Extend roof service life
Create a seamless monolithic membrane
Is Your Roof a Candidate for Restoration?
Contact us to talk through specifications, pricing or finding an applicator.
This system is intentionally built to require a high-build, fully adhered, seamless, formed-in-place monolithic restoration membrane with true waterproofing performance at substantial dry film thickness.
Products marketed primarily as roof coatings, reflective coatings, maintenance coatings, or low-build surfacing treatments are not the design intent and are not considered equivalent solely because they are field-installed.
Is Your Roof a Candidate for Restoration?
Contact the PolyArmor team about specifications, pricing or finding an applicator.
PolyArmor Hybrid is produced on controlled mixing and batching equipment engineered for repeatable film build and formulation accuracy across every production run.
